DAT-heads Digest #373, Volume #7 Thu, 27 Jan 05 11:50:01 EST Contents: Re: Derek Trucks (Mike Wren) 3:1 rule... (Nick Zuccaro) Bill "Be Bop Deluxe" Nelson (Meurglys3@att.net) Re: blumlein matrixing for surround... (Eugene Hu) ---------------------------------------------------------------------------- From: Mike Wren Subject: Re: Derek Trucks Date: Wed, 26 Jan 2005 13:15:50 -0500 (EST) http://albanystage.mikewren.com/artistsview.asp?id=24 > From: Adam Smith > Subject: Derek Trucks > Date: Tue, 25 Jan 2005 11:38:30 -0800 > > Hello, I haven't been able to access the BTAT lately. Does anyone know > if Derek Trucks allows board feeds? > Thanks, Adam ------------------------------ From: Nick Zuccaro Subject: 3:1 rule... Date: Wed, 26 Jan 2005 11:16:22 -0800 (PST) > From: "Martin" > Subject: ORTF Question > Date: Tue, 25 Jan 2005 18:33:19 -0500 > > > My question is this: > > > > Is it better to point my mics at the stacks or run ORTF with > my mics not > > pointing at the stacks? > > What about the 3:1 rule? the 3:1 rule doesn't apply to this situation, it's for when you're recording a single point source with 2 mics that are seperated by a distance (mic to mic) of more than 1 unit (from the closest mic to the source) apart. this doesn't even apply to a split omni becuase the mic-to-source distance is equal for both mics... l8r...Nick ------------------------------ From: Meurglys3@att.net Subject: Bill "Be Bop Deluxe" Nelson Date: Wed, 26 Jan 2005 21:19:45 +0000 Heads up, Anyone got a line on any recent Bill Nelson shows? If so, please get in touch with me for a divine trade. http://home.att.net/~meurglys3/ Tom ------------------------------ From: Eugene Hu Subject: Re: blumlein matrixing for surround... Date: Wed, 26 Jan 2005 14:27:21 -0800 [snip] > equipment (just like SQ and QS were / are). The disadvantage is that very > few microphones offer a figure-8 pattern (the AKG 414 is probably the most > well-known), and they're all expensive.....but I do remember seeing a > website somewhere that had instructions for building a DIY microphone with a > figure-8 pattern, it used two condenser capsules and an op-amp summing > circuit for each microphone......also, good decoding equipment is expensive > and hard to come by these days (anybody have a Tate II kicking around that > they wanna sell me?)..... For a cheap figure-8, mix the two channels of an AT-822/825 out of phase. -Eugene ------------------------------ ** FOR YOUR REFERENCE ** To unsubscribe from this digest, please send email to dat-heads-unsubscribe@datheads.phish.net If your email address has changed, you may (optionally) send the message to dat-heads-unsubscribe-oldaddress=olddomain@datheads.phish.net and the old address will be removed. Problems or questions about a subscription should be addressed via these avenues and then if needed to dat-heads-owner@datheads.phish.net or postmaster@datheads.phish.net never the list itself You can submit a message for inclusion in the next digest via this address: Internet: dat-heads@datheads.phish.net Archives of DAT-Heads digests and related files are available on the DAT-Heads home page: http://www.solorb.com/dat-heads/ End of DAT-Heads Digest ******************************